UTON vz.75
MIKOV and the Production of the UTON vz.75
Manufacturing process, original drawings and production photographs from the MIKOV factory.
UTON Production Process
Production process: blanking the blade from a steel strip → stamping the serial number → hardening and tempering the blade → grinding bevels on a semi-automatic grinder → polishing the blade → injection moulding the plastic handle core → injection moulding the rubber handle → sharpening and finishing → assembly into the sheath.
In the photographs you can see: the blanking press, the blanking tool on a shelf, the hardening furnace (UTON saws were being hardened at the time), saws immediately after hardening, the grinding room and the injection moulding press for the handle.
MIKOV and production of UTON vz.75 – photo 1
MIKOV and production of UTON vz.75 – photo 2
MIKOV and production of UTON vz.75 – photo 3
MIKOV and production of UTON vz.75 – photo 4
MIKOV and production of UTON vz.75 – photo 5
MIKOV and production of UTON vz.75 – photo 6
MIKOV and production of UTON vz.75 – photo 7
MIKOV and production of UTON vz.75 – photo 8
MIKOV and production of UTON vz.75 – photo 9
UTON Blade
The first photograph shows a blank blade cut from strip steel 4 mm wide; the next photograph shows the blade already ground to 3.6 mm.
MIKOV and production of UTON vz.75 – photo 10
MIKOV and production of UTON vz.75 – photo 11
MIKOV and production of UTON vz.75 – photo 12
UTON vz.75 – Cross-Section
UTON vz.75 – cross-section of the knife – photo 1
UTON vz.75 – cross-section of the knife – photo 2
UTON vz.75 – Original Technical Drawing
UTON vz.75 – original technical drawing
